+86-029-81161513
  • 28/Oct

    2026

    Casing Head Assembly Tested Before the BOP Lands

    The casing head assembly is the first piece of pressure equipment on a well and the one nobody wants to revisit. It is welded or slipped onto surface casing, it carries everything

  • 28/Oct

    2026

    How a Dual-flapper Check Valve Seals Twice

    Most check valves in a coiled tubing string are asked to do one thing: stop flow coming back up the pipe. A dual-flapper check valve does that with two flappers in series, and it d

  • 28/Oct

    2026

    API Coupling Wear at the Workover Rig Floor

    Tubing comes out of a well on a workover and every joint is handled at least four times: pulled, laid down, picked up and made up again. The coupling takes the tongs, the slips and

  • 28/Oct

    2026

    Dual-flapper Check Valve for Coiled Tubing Barriers

    Coiled tubing has no pipe rams to close on it mid-string, so the barrier either travels with the string or is built into it. A dual-flapper check valve sits in the bottomhole assem

  • 28/Oct

    2026

    Premium Connection Make-Up on the Casing Crew

    On a casing job the pipe is inspected, drifted and tallied before it goes in the hole, and then the whole string depends on a joint made in ninety seconds with a power tong. A prem

  • 28/Oct

    2026

    Electro-Magnetic Interference Tool Maps Three Strings

    A well that has produced for fifteen years rarely has one clean string left to inspect. There is tubing inside casing, casing inside surface pipe, and on many older completions a l

  • 28/Oct

    2026

    Memory Cement Bond Tool in Horizontal Wells

    Cement bond logging answers a question that decides the well's future: is the cement actually bonded to the casing and the formation, or is there a channel behind pipe. In a ve

  • 28/Oct

    2026

    Ultron Composite Bridge Plug for HPHT Drillout

    A composite bridge plug is chosen for two reasons: it holds pressure, and it comes out of the hole quickly. In a high-temperature, high-pressure well those two requirements pull ag

  • 28/Oct

    2026

    Spiral Drill Collar Against Differential Sticking

    Differential sticking is the quiet failure mode of a drilling job. The string is not mechanically trapped, the hole is not collapsing, and yet the pipe will not move because the mu

  • 28/Oct

    2026

    Thru-Tubing Cutter Blades for Stuck Fish

    A stuck string inside tubing is a problem with a narrow set of solutions. The fish cannot be pulled, cannot be washed over without clearance, and cannot be left because it blocks t

  • 28/Oct

    2026

    Tubing Head Assembly Load Shoulder and Seal

    The tubing head assembly is the part of the wellhead that carries the tubing. It sits above the casing head, supports the string through a hanger, and seals the annulus between tub

  • 28/Oct

    2026

    Sucker Rod Pump Barrel and Valve Selection

    A sucker rod pump is a simple machine that fails for unglamorous reasons: a barrel worn oval, a ball that no longer seats, a plunger that was specified for the wrong fluid. The pum

First 1234567 Last 1/74